FCM9002 USER MANUAL
76-02-095 Rev.B
Page 24 of 145
2.2.3 Switch 8, Master Boot Control / (Factory Default)
This bit switch will return the unit back to the factory default settings and will also
read the bit switches and configure the operating mode of the WAN port and
Auto Boot operation.
ON
Normal Operation
OFF
Return the unit to Factory Default on power up.
When a unit is returned to the factory default, the password will be returned to
the default, “FCM9002” and all IP and remote access configurations will be lost.
2.3 Rear Panel LED Indicators
The FCM9002 has eight LED indicators on the rear panel which show the port
and unit status.
2.3.1 RJ45 Led Indicators
Each RJ45 connector has two LED’s, one green and one yellow and these are
combined to show the Link State, Link Activity and Link Speed as shown below:
If the LED(s) are ON, it indicates the Link is up, and the combination of Green
and Yellow LED’s indicates the speed.
If the LED(s) are Flashing, this indicates that the link is up, and activity is
detected on the link, ie frames are being received or transmitted.
All LED’s off indicates the link is down.
