Memjet Quadient Rena MACH 6, User Manual

Page: 28 / 132

SECTION 2
INSTALLING PRINTER
24
GOOD – OK to use Printer
(All Tubes filled with Ink)
BAD – Do NOT use Printer
(Empty Tubes or lots of air in tubes)
X
OK
13. Open the Printhead Door and verify that ALL Ink Tubes are filled with ink.
Be sure to check Ink Tubes at both ends (input and output sides) of the Printhead Cartridge.
GOOD
: All Ink Tubes filled at both ends (input and output) of Printhead Cartridge. OK to use Printer.
Tip: It is normal to see a few air bubbles in Ink Tubes at the output (non-operator) side of the Printhead
Cartridge. However you should not see air bubbles in Ink Tubes at the input (operator) side.
BAD
: Empty Ink Tube(s) or a lot of air/air bubbles at either end (input/output side) of Printhead Cartridge.
14. If priming results are BAD ; please perform the following steps.
•
Use a lint free cloth, soaked but not dripping with distilled water, wet “Printhead Nozzle Area”
again. See section titled “Cleaning the Printhead” for instructions on accessing the printhead
surface with the printhead installed.
•
Immediately after wetting printhead nozzle surface, with distilled water, close all Doors.
•
Use the “Full Clean Printhead” feature to attempt to fill the Ink Tubes.
•
If issue continues try removing and reinstalling the Printhead Cartridge; see “Remove/Replace
Printhead Cartridge”.
•
If issue continues; do NOT use Printer. Call for technical support.
15. Close the Printhead Door.
WARNING
Attempting to use (print with) Printer that has empty Ink Tubes or a lot of air in the Ink
Tubes can cause permanent damage to the Printhead Cartridge (Printhead nozzles).