Memjet Quadient Rena MACH 6, User Manual

Page: 90 / 132

SECTION 4
MAINTENANCE
86
Inspect/Replace Waste Ink Tray
Waste Ink Tray catches and absorbs the waste ink produced by the system. This tray is filled with absorbent
material. This Tray, or the absorbent material within the Tray, must be replaced when it becomes saturated.
Please inspect routinely.
The tabs
[A] , located at the left and right sides of the Tray, secure the Tray to the frame.
When re-installing the Waste Ink Tray; please be sure the tabs “click” into the frame, to secure the Tray's position.
Procedure:
1. Open Ink Tank Door.
2. Pull on Tabs [A] to release and
slide Waste Ink Tray out of
Printer.
3. Inspect absorbent material within
Tray. If nearly or completely
black with ink, it is time to
replace Waste Ink Tray or
absorbent material within Tray.
4. Install Waste Ink Tray; making sure the tabs [A] “click” into the frame, to secure the Tray’s position.
Replace Sheet Separators
Sheet Separators ensure separation of pieces as they are being fed.
If experiencing double sheet feeding and cannot adjust Separators
to prevent it, replace Separators.
Procedure:
1. Turn Printer OFF and unplug it from power source.
2. Move Media Side Guides to maximum open position.
3. Release Separator by loosening Locking Knob. Then lift
and lock separators at highest position.
4. Remove screw [A] and Separator Cover [B] .
Remove Separator [C] by prying it out of Holder.
Tip : You will need to move Media Side Guides to access some separators.
5. Install a new Separator and reinstall Separator Support and screw.
DO NOT over tighten screw to prevent distorting or damaging Separator.