M
AVTM246004 BITE 2/2P Rev 4 July 2011
119
USING AVOLINK WITH THE BITE
Connecting the BITE to the PC
The BITE is physically connected to the PC by means of a null-
modem serial cable. You may power up the BITE before or after
connection to the PC, but be sure the BITE is properly and
securely connected to the PC before starting AVOLINK.
F
WARNING
Make sure the BITE is disconnected from any battery
under test before connecting the BITE to a PC.
For the BITE2 and the EBITE Receivers:
Insert the plug of
the null-modem cable (30648) into the 7-pin connector on the
BITE receiver. Then insert the 9-pin end of the null-modem
cable into the COM port on the PC.
NOTE:
Refer to EBITE manual for transferring data from
Transmitter.
For the MBITE:
Connect a null-modem cable (33533) into the
J5 connector on the MBITE connector panel. Insert the other
end into the COM port of the PC.
Starting AVOLINK
Before starting up the AVOLINK program, be sure that the PC
and the BITE are securely connected by the null-modem cable.
1.
Access the AVOLINK program by clicking on
Start
.
2.
From the Programs menu, select
AVOLINK
and then, from
the submenu,
avolink.
AVOLINK automatically sets the communication parameters at
9600 baud, 8 data bits, 1 stop bit and no parity. If you need to
change the parameters, use the
Setup Serial Port
button, as
described under "Setup Serial Port" on page 132.
www.
GlobalTestSupply
.com
Find Quality Products Online at:
