M
AVTM246004 BITE 2/2P Rev 4 July 2011
80
2.
Verify that the
transmitter
ac line voltage selector is set
for the correct ac line voltage (120 V or 230 V).
The arrow located on the connector panel directly to the
left of the J1 receptacle should point to the arrow on the
fuse carrier that corresponds to the proper voltage.
3.
Insert the ac power cord into the J1 ac receptacle. Then
plug the power cord into the (120 V or 230 V) outlet.
4.
Press the power switch to
(ON), and then the Current
On/Off switch.
5.
The
transmitter
POWER light and Current On/Off switch
should illuminate followed by the CURRENT READY
indicator. If neither indication occurs, the primary fuse
may be bad. Refer to the appropriate subsection,
"Replacing Fuses in the BITE 2 Transmitter" on page 82 or
"Replacing Fuses in the BITE 2P Transmitter" on page 85.
www.
GlobalTestSupply
.com
Find Quality Products Online at:
