Maytag MLE20PDAYW0, Service Manual

Page: 42 / 204

3-2
iMPOrTanT
electrostatic Discharge (eSD)
Sensitive electronics
ESD problems are present everywhere.
ESD may damage or weaken the
electronic control assembly. The new
control assembly may appear to work
well after repair is finished, but failure
may occur at a later date due to ESD
stress.
Use an anti-static wrist strap. Connect
wrist strap to green ground connection
point or unpainted metal in the
appliance.
-OR-
Touch your finger repeatedly to a green
ground connection point or unpainted
metal in the appliance.
Before removing the part from its
package, touch the antistatic bag to
a green ground connection point or
unpainted metal in the appliance.
Avoid touching electronic parts or
terminal contacts; handle electronic
control assembly by edges only.
When repackaging failed electronic
control assembly in antistatic bag,
observe above instructions.
n
n
n
n
Scrolling “OuT OF OrDer” Followed By
Diagnostic Code Showing in Display
This condition indicates the washer or dryer is
inoperative. Diagnostic codes being displayed
on the upper portion of the display pertain
to the dryer section, and diagnostic codes
displayed on the lower portion of the display
apply to the washer section. Diagnostic
codes displayed on both the upper and lower
portions of the display pertain to the control
system of both the washer and dryer.
“0 Minutes” Showing in Display
This indicates the cycle is complete and the
washer/dryer cannot be operated. Coins
dropped or debit inputs during this condition
will be stored in escrow but cannot be used
until normal operation is restored by opening
and closing the door. If a door switch has
failed, causing “0 MINUTES” to remain in the
display after the door is opened and closed, it
must be replaced before normal operation can
be restored.
Cold Start (initial use)
Washer/dryer is programmed at the factory as
follows:
11 minute wash period
3 rinses (extra rinse not enabled)
$1.75 wash price (PD models)
$0.00 wash price (PR models)
Dryer is programmed at the factory as follows:
45 minutes dry time for PR models
5 minutes per quarter for PD models
$1.50 dry price (fixed cycle with top off, PD
models)
$0.00 dry price (fixed cycle, PR models)
n
n
n
n
n
n
n
n
Electrical Shock Hazard
Disconnect power before servicing.
Replace all parts and panels before
operating.
Failure to do so can result in death or
electrical shock.
General uSer
inFOrMaTiOn