Maytag MLE20PDAYW0, Service Manual

Page: 105 / 204

4-49
There is a gasket, that seals the tub halves
together, in the channel around the edge of
the rear outer tub. This gasket should be
replaced after separating the outer tub.
When reassembling the outer tub halves,
place the metal clips at each location of two
raised indicators.
Tap the clips onto the tub with a hammer.
There may be more clip locations than
there are clips. Hopefully the technician has
marked the positions that did not start with
a clip. When a new tub is installed, use the
extra clips supplied with replacement tub.
27.
28.
29.
30.
Mark any position on the outer tub that
does not have a clamp.
Remove the tub clamps by prying them off
with a flat blade screwdriver.
Press the tab on 2 of the 3 guides around
the edge of the tub to release the tub
halves. These guides will assist in re-
aligning the tub halves during reassembly.
Lift rear half of the tub off the spin basket.
The bearings and seals are located in
the rear half of the outer tub. These parts
are replaced together as an assembly, not
individually.
22.
23.
24.
25.
26.
Alignment
Guide Tab
Spin Basket
Bearing
And Seal
Gasket
Raised
Indicators