Maytag MLE20PDAYW0, Service Manual

Page: 181 / 204

6-15
WaTer valve lOCaTiOnS
Water Valve Locations
H
C
Hot Inlet
Valve #1
Cold Inlet
Valve #2
Cold Inlet
Valve #3
WaSHer CCu Wire
HarneSS COnneCTOr
TaBle
Unplug washer/dryer or disconnect power
before taking ohm measurements.
1
1
1
1
1
1
(
Ω
) Ohm Abnormal Pin Wire
Terminal Component Value Value Connectors* Coding
* *The number 1 pin has been marked on the bottom part of the connector.
measurements.
HE2 Wax Motor 1.2k
Ω
Infinity** 1, 2
at 25°C
DLS2 Door Locked Switch Continuity: 1, 2
Locked/Unlocked door locked.
No Continuity:
door unlocked.
DL3 Door Lock Coil 165
Ω
Infinity** 1, 3 door lock
Locked or Unlocked 3, 5 door unlock
TH2 Temperature Varies with Infinity** 1, 3
Sensor temperature
changes.
See above.
DP2 Drain Pump 13
Ω
Infinity** 1, 3
DS2 Door Switch Continuity 1, 3
at door close.
No continuity
at door open.
DI6 Hot Inlet Valve #1 812
Ω
Infinity** 1, 3 (hot
valve #1)
VCH7 Cold Inlet Valve #2 812
Ω
, Infinity** 1, 3 (cold
Cold Inlet Valve #3 either coil (or more than valve #2)
10% lower 5, 7 (cold
or higher) valve #3)
IF2 RFI/UIC Transformer 30
Ω
Infinity** 1, 2
(or more than
10% lower
or higher)
PR6 Pressure Switch Infinity** for all Continuity at any 1, 2
except 4, 6 switch except 3, 4
with no water 4, 6 with no 4, 5
in tub water in tub 4, 6
**The number 1 pin has been marked on the
bottom part of the connector.
**An infinity measurement occurs when the
multimeter does not detect an ohm reading.
Unplug washer or disconnect power.
Remove the washer lower service panel
Reach up along the inside of the front panel
and locate the bottom of the door switch /
lock assembly.
Located on the bottom of the door switch /
lock assembly is a tear-drop shaped tab.
To unlock a locked door gently pull the tab
down about 1/4” or until a click is heard.
The door may be opened.
1.
2.
3.
4.
5.
6.
Manually unlOCkinG
THe DOOr laTCH
Manually unlaTCHinG
TriPPeD DOOr laTCH
If the latch has been tripped, with the door
open, by something being poked into the
latch, it must be unlatched before the door
will be able to be closed again. There are
two ways this can be done:
Remove the door lock assembly and
turn it over to view the back of the latch
mechanism. Press the white plastic of the
latch and sliding it slightly, to position the
metal bar at the back of the plastic latch
mechanism.
With the proper tool and knowledge it
may not be necessary to remove the latch
assembly to reset the trip mechanism.
Using a strong metal scribe with a narrow
90 degree hook at one end, the latch can be
pulled from the front to unlatch it.
1.
2.