Maytag MLE20PDAYW0, Service Manual

Page: 140 / 204

4-84
Remove the control panel bracket
(See page 4-10).
Remove two star head screws that secure
bracket.
Lift bracket off coils.
Lift coils off posts and disconnect wire
connector from each coil.
nOTe: An MOV is present in the wire
harness to the gas valve coils. This Metal
Oxide Varistor, “MOV”, is used as a voltage
and/or heat dissipating device for protection
of the gas valve coils.
nOTe: Be aware that there is supposed to
be a metal sleeve on the post under the split
coil that has 3 terminals.
1.
2.
3.
4.
reMOve GaS valve COilS
Remove the control panel bracket
(See page 4-10).
Remove two 1/4” hex head screws that
secure the brace to the bottom of the dryer.
Lift brace out of dryer
Use a 1” (25 mm) open end wrench to
remove gas line from valve.
Remove two 1/4” hex head screws under
the bracket that secure the gas valve
bracket and remove it from dryer.
1.
2.
3.
4.
reMOve GaS Burner
aSSeMBly
Two Star
Head Screws
Two 1/4” Hex
Head Screws
Gas Line
Electrical Shock Hazard
Disconnect power before servicing.
Replace all parts and panels before
operating.
Failure to do so can result in death or
electrical shock.
Electrical Shock Hazard
Disconnect power before servicing.
Replace all parts and panels before
operating.
Failure to do so can result in death or
electrical shock.
Two 1/4” Hex
Head Screws