Maytag MLE20PDAYW0, Service Manual

Page: 23 / 204

2-9
Hot and cold water faucets located within
4 ft. (1.2 m) of the hot and cold water fill
valves, and water pressure of 20–100 psi
(137.9–689.6 kPa).
A level floor with a maximum slope of 1” (25
mm) under entire washer/dryer. Installing
the washer/dryer on soft floor surfaces, such
as carpets or surfaces with foam backing, is
not recommended.
A sturdy and solid floor to support the
washer/dryer with a total weight (water and
load) of 450 lbs (204 kg).
A floor drain under the bulkhead.
Prefabricated bulkheads with electrical
outlets, water inlet lines, and drain facilities
should be used only where local codes
permit.
n
n
n
n
STaCkeD WaSHer/eleCTriC Dryer
lOCaTiOn reQuireMenTS
Selecting the proper location for the washer/
dryer improves performance and minimizes
noise and possible washer “walk.”
The washer/dryer can be installed in a
basement, laundry room, or recessed area.
See “Drain System.”
Companion appliance location requirements
should also be considered.
iMPOrTanT: Do not install or store the
washer/dryer where it will be exposed to the
weather. Do not store or operate the washer/
dryer in temperatures at or below 32°F (0°C).
Some water can remain in the washer and
can cause damage in low temperatures.
Proper installation is your responsibility.
You will need:
A water heater set to deliver 120°F (49°C)
water to the washer.
A grounded electrical outlet located within
6 ft. (1.8 m) of where the power cord is
attached to the back of the washer. See
“Electrical Requirements.”
n
n
Explosion Hazard
Keep flammable materials and vapors, such as
petrol, away from dryer.
Do not install in a garage.
Failure to do so can result in death, explosion,
or fire.
WARNING