USE AND MAINTENANCE
ENGLISH
Cod. F07022163
pag.61
9.13.1_GREASING
Lubricate and grease all the points indicated by the special adhesive signs:
“B07500214”
, present on the
machine every 30 hours of work.
Lubricate and grease all the points indicated by the special adhesive
signs:
B07500214
, present on the machine every 30 hours of work.
Grease lubricate the cardan shaft following the instructions
contained in the instruction handbook supplied with the cardan
shaft.
9.14_HYDRAULIC OIL
The hydraulic controls are high precision components and require clean filtered oil:
Regularly check the level and state of contamination.
Check the seal and locking of the hydraulic tubes and for any oil leaks.
Check and top up the oil in the transmission box and the automatic oil tank.
IMPORTANT! Use the oils advised by MASCHIO FIENAGIONE in chapter
“9.13_Lubrication”
;
another type of oil could create pumping problems.
9.14.1_AUTOMATIC OILING OF THE CHAINS
The round baler is provided with an automatic oiling system for the chains.
This system works every time the tailgate closes by means of the movement of a small pump.
The flow of oil can be regulated by adjusting the travel of the piston
"
P
"
located on the small pump.
If the flow of oil coming out is too low or too high, adjust the distance
"
D
"
so as to increase or decrease the
travel of the piston of the small pump:
Open the left lateral protection guard and move to a position
where you can reach the small automatic oiling pump located
directly under the hinge of the guard.
Loosen the two hexagonal bolts
"V"
and slide the pump along
the slots in order to increase or decrease the stroke of the piston
“P”.
THE SMALLER
the stroke of the piston
“P”
the greater is the flow of oil pumped and put into
circulation by the automatic lubrication system of the chains.
THE GREATER
the stroke of the piston
“P”.”
the smaller is the flow of oil pumped and put into
circulation by the automatic lubrication system of the chains.
THE MAXIMUM STROKE ALLOWED IS 10 mm.
After making the adjustment, tighten the two socket head screws and close the left lateral guard.
V
P
