USE AND MAINTENANCE
ENGLISH
Cod. F07022163
pag.57
9.7_ELECTRICAL AND ELECTRONIC COMPONENTS
Check that the cables of the electrical system and the control unit have not been crushed or damaged.
Check that all the sockets, plugs, cables and sensors are always cleaned of any deposits of earth or the
product.
Check and if necessary replace broken bulbs in the lighting system.
Further information regarding the maintenance of the control unit can be found in the chapter
“10_Control
System FF Control”.
IMPORTANT! After the first 200 bales produced check the machine in regard to the points
described above.
9.8_ADJUSTING THE PICK-UP UNIT
9.8.1_ADJUSTING THE WORKING HEIGHT OF THE PICK-UP
The working height of the pick-up is adjusted by moving the small wheels to one of the predetermined
positions in the same way on each side of the pick-up.
IMPORTANT! The pick-up tines must never touch the ground; therefore adjust the working
height of the pick-up so that the pick-up tines remain above the ground by a minimum of
2÷3cm.
For further information consult the paragraph
“7.6.4_ Adjusting the pick-up wheels”.
9.8.2_HYDRAULIC RAISING OF THE PICK-UP
You can raise and lower the pick-up easily using two lateral hydraulic jacks, by
moving the lever of the hydraulic distributor on the tractor, first opening the
stop valve (valve lever in the
"
OPEN
"
position).
For further information consult the paragraph
“7.4.3_ Connection of the hydraulic system”.
OPEN
