ENGLISH
USE AND MAINTENANCE
pag.60
Cod. F07022163
9.10_WHEELS AND TYRES
Tyres of various dimensions can be fitted on the round baler. Check the inflation pressure regularly for the type
of tyre fitted to you machine referring to the pressure values given in the table
“11.5_Tyre pressure values”.
The inflation pressure of the
pick-up wheels
should be:
2.5bar
.
Check the torque of the nuts on the stud bolts of the wheel hubs regularly. It should be
250Nm (184 lb-ft)
.
Repairs to the wheels and tyres must be done by specialised personnel provided with
suitable equipment.
9.11_BOLT TIGHTENING
Regularly check the securing bolts and screws and if necessary adjust them to the torque values advised in
the table
“11.4_Torque settings”
.
Check if all the bolts are correctly tightened after the first three hours of work.
Check if all the screws and bolts are correctly tightened after the first 10 bales formed by the machine.
Annually retighten the screws holding the drawbar chassis to 240Nm (177 lb-ft)
Annually retighten the screw holding the towing eye to 475Nm (350 lb-ft)
9.12_WELDING
WARNING! FIRE RISK!
Never do welding work on your baler when there is a bale inside the
chamber.
Before doing welding work on your baler:
Stop the tractor, remove the keys from the dashboard and wait for all the
moving parts of the machine to stop completely.
Disconnect all the electrical and electronic functions
Switch off the control system.
For further information consult the chapter
“4.2_Safety warnings”
.
In any case take great care in these operations.
9.13_LUBRICATION
Regular lubrication is the best guarantee against breakdowns and repairs. Apply lubricants regularly and
always use good quality greases and oils.
IMPORTANT!
In general use grease type: AGIP GR MU EP0
In the transmission box use oil type: AGIP BLASIA EP 150
In the automatic oil system tank for the chains use oil type: AGIP OSO 100
IMPORTANT! Observe the laws in force in your country regarding the use and disposal of oils
and lubricants.
Lubricate and grease all the rotating part: crown wheels, supports, bearings, chains, pins and shafts.
WARNING! Always apply lubricants in respect of the safety regulations contained in the
chapter
“4_General safety regulations”
.
Before greasing or oiling you baler:
Stop the tractor, remove the keys from the dashboard and wait for all the
moving parts of the machine to stop completely.
Switch off the control system.
Note:
if it should be necessary to open or remove any guards in order to access the various lubrication
points, always remember to close and reposition them afterwards.
