ENGLISH
USE AND MAINTENANCE
pag.70
Cod. F07022163
10.2_INSTALLATION
Check that you have the following material available in the box
provided with the machine:
1)
Feeder cable
2)
Terminal
3)
Dovetail
10.3_INSTALLATION ON THE TRACTOR
10.3.1_FEEDER CABLE
With the tractor switched off, disconnect the battery earth wire, then connect the feeder cable to the terminals
of the 12 V battery, connecting the red wire
(+)
to the positive pole and the black wire
(-)
to the negative pole.
Reconnect the earth wire.
CAUTION!
Some feeder cables may be brown or blue. In this case the brown wire is the positive
(+)
and
the blue wire is the negative (-).
Make sure not to invert the polarity.
Secure the cable along the tractor so as to bring the COBO connector to the height of the drawing eye or near
the PTO.
WARNING!
Once the cable of the machine is connected take care not to non collide with the
PTO and do not obstruct the working movements of the machine.
10.3.2_DOVETAIL AND CONTROL UNIT
Fix the dovetail in the tractor cabin so that the terminal can be reached easily by the operator.
The terminal is inserted on the dovetail during work.
10.4_CONNECTING THE MACHINE TO THE TRACTOR
10.4.1_DATA TRANSMISSION CABLE
Connect the transmission data cable provided with rectangular 24 pin connector located on the drawbar of the
machine to the control unit.
Push the control unit into the dovetail fitting previously installed in the cabin.
10.4.2_POWER CABLE
Now connect the power cable of the machine to the power cable of the tractor.
Make sure that the tab of the cover of the female COBO connector of the power cable of the machine is
inserted in the slot of the male COBO connector of the power cable of the tractor.
This will prevent accidental disconnection of the two cables with consequent blackout of the system.
WARNING!
Check that the cables do not obstruct driving movements and are not near to
moving parts.
To check the connection turn the
ON-OFF key
of the control unit in position and check that it comes on.
Further information concerning the connection of the control system is given in the paragraph
“7.4.1_Connection of the control system “FF_Control”.
1
2
3
