ENGLISH
USE AND MAINTENANCE
pag.50
Cod. F07022163
9.2_MAINTENANCE AND ADJUSTMENT OF SAFETY DEVICES
Some of the safety devices listed in chapter
“4.5_Safety devices”
of this manual need to be reset and/or
adjusted after they have come into action.
9.2.1_REPLACING THE PICK-UP SAFETY DEVICE
If the shear bolt located on the safety device of the pick-up should break, replace it with one of identical quality:
Bolt “B” TE M8X 45-10.9 UNI5738 – DIN 960
(not galvanised; partially threaded).
Loosen the screws and pull out the safety guards located on the left side.
Remove the bolt and make sure that there are no pieces of the sheared bolt caught between parts of the
transmission.
Realign the safety device holes, manually rotating the screw feeder; reinsert the new bolt and tighten it.
Remount the safety guards and replace the screws.
9.2.2_REPLACING THE FEED DEVICE TRANSMISSION SAFETY DEVICE
If the bolts located on the feed device transmission safety device should break replace them with bolts of
identical quality:
bolts “B” TE M8X 40-8.8 UNI5737.
Round baler model ENTRY 120 (left side)
Loosen
the
screws
and remove the safety guards located on the left side.
Remove the bolt and make sure that there are no pieces of the sheared bolt caught between parts of the
transmission.
Re-align the holes of the safety device, by rotating the gear by hand; fit the new bolts and tighten.
Refit the guards and tighten the screws.
Round baler model ENTRY 150 (right side)
Open the right lateral guard.
Remove the bolt and make sure that there are no pieces of the sheared
bolt caught between parts of the transmission.
Re-align the holes of the safety device, by rotating the gear by hand; fit the
new bolts and tighten.
Close the right lateral guard.
B
B
B
