Magnetek Impulse G+ series 4, Instruction Manual

Page: 109 / 276

IMPULSE®•G+ & VG+ Series 4 Instruction Manual – February 2017
5-23
Electronic Programmable Limit Switches (EPLS)
Using the motor revolutions (U01-51) from the Height measurement function, it is possible to
program UL1, UL2, LL1, and LL2 positions without the use of rotary limit switches. When C03-16,
C03-17, C03-18, or C03-19 has a value other than 0, the EPLS function will be enabled. Height
measurement must be correctly setup before using EPLS.
Table 5-23: Electronic Programmable Limit Switches Parameter Settings
NOTE: A setting of 0 disables that specific limit.
Table 5-24: Limit Switch Outputs
Figure 5-10: EPLS Parameter Layout
Parameter Display Range Default Model
C03-16 UL2 Revolutions 0–65535 Rev 0 VG+
C03-17 UL1 Revolutions 0–65535 Rev 0 VG+
C03-18 LL1 Revolutions 0–65535 Rev 0 VG+
C03-19 LL2 Revolutions 0–65535 Rev 0 VG+
H02-0x or F05-0x = Function
2B - Upper Limit 1 Output ON when keypad displays UL1
2C - Upper Limit 2 Output ON when keypad displays UL2
2D - Lower Limit 1 Output ON when keypad displays LL1
2E - Lower Limit 2 Output ON when keypad displays LL2
30 - Lower Limit Output ON when keypad displays LL1 or LL2
31 - Up/Low Limit Output ON when keypad displays UL1, UL2, LL1, or
LL2