Magnetek Impulse G+ series 4, Instruction Manual

Page: 218 / 276

IMPULSE®•G+ & VG+ Series 4 Instruction Manual – February 2017
5-132
U01-12
Int Ctl Sts 1 Operation Status --
U01-14
CPU 1 SW Number Flash ROM software ID number --
U01-15
Term A1 Level External Terminal Input level %
U01-16
Term A2 Level External Terminal Input level %
U01-17
Term A3 Level External Terminal Input level %
U01-20
SFS Output Primary freq. after the SFS Hz
U01-21
AI Opt Ch1 Level Displays the input voltage to terminal V1 on analog input
card AI-A3.
%
U01-22
AI Opt Ch2 Level Displays the input voltage to terminal V2 on analog input
card AI-A3.
%
U01-23
AI Opt Ch3 Level Displays the input voltage to terminal V3 on analog input
card AI-A3.
%
U01-24
Opt Out Displays the output from the option card S4IO - 8 bits. --
U01-25
Opt In Low Displays the reference value input from the DI option card
(DI-A3, S4I, or S4IO) lower 8 bits.
--
U01-26
Opt In High Displays the reference value input from the DI option card
(DI-A3, S4I, or S4IO) upper 8 bits.
--
U01-28
CPU 2 SW Number ROM ID --
U01-29
Load Weight Monitors load weight when C10-01 is enabled C10-06
U01-30
SS Delta Speed Snap Shaft Delta Speed between Ch1 and Ch2 after gear
ratio
Hz
U01-34
OPE Error Code Displays the parameter number that caused the OPExx or
Err (EEPROM write error) error.
--
U01-39
Transmit Error Displays the contents of a MEMOBUS/Modbus error --
U01-44
ASR Out w/o Filter Output monitor from Speed Control loop (Primary Delay filter
input value). 100% is displayed at motor rated secondary
current.
%
U01-50
Hook Height Percentage of Hook height is displayed. This will display 0%
until the system is homed.
%
U01-51
Motor Revolution Number of revolutions after Home with respect to Home. Revs
Parameter Display Function Units