Magnetek Impulse G+ series 4, Instruction Manual

Page: 216 / 276

IMPULSE®•G+ & VG+ Series 4 Instruction Manual – February 2017
5-130
If all the parameters stored in the digital operator do not match those programmed in the Drive, the
digital operator displays the following:
The digital operator will not display which parameters did not match, only that the verification found
discrepancies in some parameter values.
NOTE: In order to properly use the COPY or VERIFY functions, the following Drive information
must be identical between the Drive that the parameters were read from and the Drive that
the parameters are written to:
Model Number (e.g. 5001-G+S4)
Software Number (e.g. 14700 also known as FLASH ID)
Control Method (e.g. A01-02)
Motion (e.g. A01-03)
NOTE: Reference the Copy Function Related Faults section in Chapter 6 for additional copy
function troubleshooting.
VYE
VERIFY ERROR