![background image](http://html1.mh-extra.com/html/lutron-electronics/grafik-eye-qsgr-3p/grafik-eye-qsgr-3p_installation-and-operation-manual_1950623054.webp)
®
GRAFIK Eye
®
QS Control Unit Installation and Operation Guide 54
Timeclock Operation (continued)
Adding an Event
1. Enter programming mode.
2. Use the Master buttons to highlight “Timeclock” and press
the “OK” button to accept.
3. Use the Master buttons to highlight “Add events” and press
the “OK” button to accept.
4. Use the Master buttons to highlight the recurrence for this event: day of the week, holiday, weekdays or
weekends. Press the “OK” button to accept.
5. Use the Master buttons to highlight the location of the timeclock event (local or remote). Press the
“OK” button to accept.
• Local events affect scenes controlled by the GRAFIK Eye
®
QS Control Unit
• Remote events affect scenes controlled by another device on the QS link (e.g. Energi Savr Node
TM
QS)
Note:
Remote timeclock events provide a virtual timeclock to devices on the QS link without a built-in
timeclock. This allows the GRAFIK Eye
®
QS control unit to activate scenes on other devices without
affecting the space it controls.
6. Use the Master buttons to highlight the type of the event (fixed time of day or a relative time to sunrise or
sunset). Press the “OK” button to accept.
7. For a fixed-time event, use the Master buttons to highlight the hour for your event to begin; press the
“OK” button to accept. Repeat for the minutes.
For a relative time event, use the Master buttons and the “OK” button to set the hour, then the minutes
relative to sunrise or sunset (maximum of 1 hour, 59 minutes before or after sunrise or sunset).
8. Use the Master buttons to highlight the desired action for the timeclock event:
• Scenes 1-16, Off
• Shade Groups 1-3 open, preset, or close
• Start/End Afterhours
• Enable/Disable Occupancy
• Enable/Disable Occupied Events
• Enable/Disable Daylighting
9. The info screen will confirm that your event has been saved.
10. Repeat steps 4 through 9 for additional events.
11. Exit programming mode.
Main menu
Timeclock
Scene setup
Timeclock
Add events
Monday
Add events
Time of day
Add events
Scene
Scene 1
Set time
: 00 AM
08
Saved
Timeclock
View events
Add events
Add events
Local
OK
Master
buttons
“OK”
button