®
GRAFIK Eye
®
QS Control Unit Installation and Operation Guide 29
Occupancy Sensor Setup (continued)
Zone Mode
This step allows you to assign up to four occupancy sensors per zone to the GRAFIK
Eye
®
QS control unit. Sensors can be added to more than one zone.
Selecting Sensors
1. If not already done, associate sensors and set to “Zone Mode.”
2. Use the Master buttons to highlight “Setup” and press the
“OK” button to accept.
3. You can assign up to four sensors per zone, and a sensor can
be assigned to more than one zone. Use the Master buttons to
scroll through the sensors until the one you wish to assign or
unassign is highlighted, and press the “OK” button to select it.
4. Use the zone raise and lower buttons for each desired zone
to assign or unassign the sensor to that zone. The zone raise
button assigns the displayed sensor, and the zone lower button
unassigns it. Press the Timeclock (back) button to return to the
list of available sensors. Once a sensor has been assigned,
it will appear with an asterisk (*) in the sensor list. Repeat for
additional sensors.
Note:
If wireless sensors are not found, verify that they are
associated correctly.
Setting the Sensor Action
1. Press the Timeclock (back) button to return to the Occ Sensor
screen. Use the Master buttons to highlight “Actions” and press
the “OK” button to accept.
2. Use the zone raise and lower buttons to adjust each zone to the
desired occupied level and press the “OK” button to save.
To set a zone as unaffected, lower the light levels all the way to
off, then hold the zone lower button for 3 seconds. The screen
will display “---” and the three middle LEDs for the zone will be
lit to indicate this zone is unaffected by the scene (the zone will
not change when this scene is initiated).
3. Use the zone raise and lower buttons to adjust each zone to the
desired unoccupied level, and press the “OK” button to save.
4. Exit programming mode.
Sensor
Set Zones
Occupied
Select Occupied
Level
Zone raise: Press to
assign the displayed
sensor
Zone lower: Press to
unassign the displayed
sensor
Occ Sensor
Labels
Setup
Sensor x/y
xxxxxxxx
yyyy-yyyy
RF
Unoccupied
Select Unoccupied
Level
Saved
Saved
3 seconds
Occ Sensor
Setup
Actions
Saved
Searching
OK
Master
buttons
“OK”
button
Timeclock
(back) button
Sensor *x/y
xxxxxxxx
yyyy-yyyy
RF
