![background image](http://html1.mh-extra.com/html/lutron-electronics/grafik-eye-qsgr-3p/grafik-eye-qsgr-3p_installation-and-operation-manual_1950623042.webp)
®
GRAFIK Eye
®
QS Control Unit Installation and Operation Guide 42
Associating the QS IR Eye with a GRAFIK Eye
®
QS control unit (continued):
Note:
For use with Lutron
®
remote models MIR-ITFS and C-FLRC.
1.
Point the IR remote at the QS IR Eye. To enter programming mode, press
and hold the “On” (top) button on the remote for 5 seconds, then, within
1 second, press and hold the “Off” (bottom) button on the remote for
5 seconds. The LED on the QS IR Eye will begin to flash slowly. Press
the “OK” button on the GRAFIK Eye
®
QS control unit to continue.
2a.
To assign the QS IR Eye as a zone controller, use the Master buttons to
select “Zone” and press the “OK” button to accept. Use the zone raise/
lower buttons on the GRAFIK Eye
®
QS control unit to select a desired
preset level, then press the zone raise and lower buttons simultaneously
for 1 second (until the zone LEDs flash at the programmed preset level).
Repeat for all zones you wish to assign to the QS IR Eye. The info screen
will confirm that your settings have been saved.
OR
2b.
To assign the QS IR Eye as a scene controller, use the Master buttons
to select “Scene” and press the “OK” button to accept. Use the Master
buttons to select “Favorite,” and press the “OK” button to accept. Use
the Master buttons to select your desired favorite scene, and press the
“OK” button to accept. Press and hold the top scene button on the
GRAFIK Eye
®
QS control unit for 3 seconds (until the scene LEDs flash).
The info screen will confirm that your settings have been saved.
3.
Point the IR remote at the QS IR Eye. To exit programming mode, press
and hold the “On” (top) button on the remote for 5 seconds, then, within
1 second, press and hold the “Off” (bottom) button on the remote for
5 seconds.
Button Setup
Favorite
Scene
1
IR Setup (continued)
Saved
Saved
Saved
Saved
OK
Press and
hold the
top scene
button for
3 seconds
to associate
QS IR Eye
Master
buttons
“OK”
button
IR Eye
Change type?
Press OK
Change type?
Scene
Change type?
Zone
Change type?
Favorite
QS IR Eye
LED
Zone LEDs
Zone Raise
Zone Lower
OR
MIR-ITFS
C-FLRC