®
GRAFIK Eye
®
QS Control Unit Installation and Operation Guide 38
Associating the Pico
®
wireless control through a QS Sensor Module (QSM):
(for wired or wireless enabled GRAFIK Eye
®
QS control units)
1.
Press and hold the “Program” button on the QSM for 3 seconds
to enter programming mode. There will be 1 audible beep and
the Status LED will begin flashing. The info screen on the
GRAFIK Eye
®
QS control unit will display that the QSM is in
programming mode.
2.
Press and hold the bottom button on the Pico
®
wireless control
for 6 seconds. There will be 3 audible beeps from the QSM to
verify association.
3.
Press and hold the “Program” button on the QSM for 3 seconds
to exit programming mode.
4.
On the Pico
®
wireless control, press and hold the top (on)
and bottom (off) buttons for 3 seconds, until the LEDs on the
GRAFIK Eye
®
QS control unit begin to flash and the QSM
beeps 1 time. Press the “OK” button on the GRAFIK Eye
®
QS
control unit to select the desired operation mode for the Pico
®
wireless control
.
5.
To assign the Pico
®
wireless control as a zone controller, use
the Master buttons to select “Zone” and press the “OK” button
to accept.
5a.
Use the zone raise/lower buttons for a zone to select a desired
preset level, and then press the zone raise and lower buttons
simultaneously for 1 second (until the zone LEDs flash at the
programmed preset level). Repeat for all zones you wish to
control with the Pico
®
wireless control.
5b.
To program other Pico
®
wireless control buttons (not including
Raise/Lower), press the desired button and repeat step 5a.
OR
6.
To assign the Pico
®
wireless control as a scene controller,
use the Master buttons to select “Scene” and press the “OK”
button to accept. Use the Master buttons to select the desired
starting scene for the Pico
®
wireless control and press the “OK”
button to accept. Press and hold the top scene button on the
GRAFIK Eye
®
QS control unit for 3 seconds (until the scene
LEDs flash).
7.
On the Pico
®
wireless control, press and hold the top and
bottom buttons for 3 seconds until the LEDs on the GRAFIK
Eye
®
control unit stop flashing and the QSM beeps 1 time.
Pico
®
Wireless Control Setup (continued)
“Program” button
QS Sensor Module
(QSM)
Top/On
button
Bottom/Off
button
Pico
®
Wireless
Control
Change type?
Zone
Change type?
Scene
Saved
Saved
QSM
Change type?
Press OK
QSM
Programming
OR
Button Setup
First Scene
Scenes 1–2, off
1
