®
GRAFIK Eye
®
QS Control Unit Installation and Operation Guide 16
Assigning Load Types
1. Enter programming mode.
2. Use the Master buttons to highlight
“Zone setup” and press the
“OK” button to accept.
3. Use the Master buttons to highlight
“Load type.” Press the “OK” button
to accept. See “Setting Load Types”
table on the next page.
4. Use the zone raise/lower buttons
to choose the load type for that
zone. See the list on the next page
for supported load types. Press the
“OK” button to accept.
5. The info screen will confirm that
your load type has been saved.
6. Exit programming mode.
Zone Setup
OK
Master
buttons
“OK” button
Main menu
CCI Setup
Zone setup
1
2
3
4
5
6
Use the
zone
raise/lower
buttons to
choose the
load type for
that zone.
Zone Setup
Non-Dim Load Type
Load Type
Set zones
Saved
Load Type
Assigning Non-Dim Load Types
Zones assigned to non-dim loads have five available configurations:
• LOFO: Last On, First Off
• FOFO: First On, First Off
• FOLO: First On, Last Off
• LOLO: Last On, Last Off
• 60/40: On at 60%, off at 40%
Scenes made up of both dim and non-dim
load types will toggle the non-dim loads before
the dim loads in a “First” on/off configuration,
and after the dim loads in a “Last” on/off
configuration.
1. Enter programming mode.
2. Use the Master buttons to highlight “Zone
setup” and press the “OK” button to accept.
3. Use the Master buttons to highlight “Non-Dim
Load type.” Press the “OK” button to accept.
See “Setting Load Types” table on the
next page.
4. Use the zone raise/lower buttons to choose
the non-dim load type for that zone. (Zones
not programmed as non-dim will be displayed
as Unaffected.) Press the “OK” button to
accept.
5. The info screen will confirm that your load type
has been saved.
6. Exit programming mode.
Main menu
CCI Setup
Zone setup
Zone Setup
Load Type
Load Type
Set zones
Saved
Non-Dim Load Type