®
GRAFIK Eye
®
QS Control Unit Installation and Operation Guide 17
Zone Setup (continued)
Load Type Notes
• All electronic low-voltage
(ELV) lighting used with an
interface must be rated for reverse
phase control dimming. Before
installing an ELV light source,
verify with the manufacturer that
their transformer can be dimmed.
When dimming, an ELV interface
(such as the PHPM-PA-DV-WH)
must be used with the control
unit.
• For all DMX or RGB/CMY DMX
lighting, an external DMX interface
(such as the QSE-CI-DMX) must
be used with the control unit.
• Maximum total lighting load for
Lutron
®
Tu-Wire
®
and Advance
Mark X
®
electronic dimming
ballasts (120 to 127 V
~
only)
must not exceed 6 A per zone
or 16 A per unit.
Zone ratings:
• Not all zones must be connected;
however, connected zones must
have a minimum load:
120 - 127 V
~
: 25 W
220 - 240 V
~
: 40 W
• Maximum zone loads:
120 - 127 V
~
: 800 W
220 - 240 V
~
: 1200 W
• Maximum total lighting load for
magnetic low-voltage (MLV) varies
by input voltage:
120 - 127 V
~
: 800 VA / 600 W
220 - 240 V
~
: 1200 VA / 960 W
LUTRON
LUTRON
Setting Load Types
Direct control via
GRAFIK Eye
®
QS
control unit
Control via
power module or
interface
Fixture load type
Choose this load type from the menu
on the GRAFIK Eye
®
QS control unit:
Zones
1 – 6
Incandescent
Incandescent
Power module
MLV (magnetic low-voltage)
MLV
Power module
ELV (electronic low-voltage)
—
Power module
Hi-Lume
®
/Eco-10
®
—
Fluorescent module
0-10 V
—
Fluorescent module
Non-dim lighting loads
Non-dim
Non-dim
Neon/Cold cathode
Neon, CC
Neon, CC
Tu-Wire
®
Tu-Wire
Tu-Wire
Advance Mark X
®
Tu-Wire
Tu-Wire
DMX
—
DMX
RGB/CMY DMX
—
RGB/CMY DMX
Cree LR4/LR6 LED
Cree LR4/LR6 LED
Fluorescent module
LED
Incandescent*
Power module
* Use incandescent load type unless otherwise specified in the LED product selection tool available at www.lutron.com/ledtool.
Power
module or
interface
