Lucent Technologies CAJUN M770, User Manual

Page: 38 / 266

Chapter 3 How to Use the Command-line Interface
20 Cajun M770 ATM Switch User’s Guide
For example, the output of the
tree
command from the
pport
functional
group prompt is:
Note:
Certain functional groups in the hierarchy are also commands in their own
right. For example, the
vport show
functional group is also a command when
entered on its own.
Conventions used to describe commands
Throughout this chapter the following conventions are used:
• All command examples are given in relation to the root of the hierarchy. That
is, this is how you would enter the command if you were at the root of the
hierarchy.
• The syntax of commands are described using the symbols displayed in Table
3.2.
Command:
M15-155s8:/pport>tree
Output:
pport
+-disable -- Disable a physical port
+-enable -- Enable a physical port
+-reset -- Reset all settable parameters on a physical port to their defaults
+-set -- Set a physical port parameter
| +-framing -- Specify the framing
| +-payloadscrambling -- Specify whether payload scrambling is on or off
| `-txrate -- Specify port transmit rate in Kbits/sec
+-show -- Show information about all physical ports
| `-counters -- Show counter information for a physical port
Table 3.2 Symbols used to describe command syntax
Syntax Description
[ ] Characters surrounded by square brackets denote optional
arguments.
{ } Characters surrounded with braces denote a selection list. When
there are several argument selections surrounded by braces and
separated by a vertical bar (|) then one of the arguments must be
included in the command.
< > Characters surrounded by angle brackets denote information that
you must provide.