Lucent Technologies CAJUN M770, User Manual

Page: 242 / 266

Appendix B Using BOOT Loader
224 Cajun M770 ATM Switch User’s Guide
Activating a configuration file
You can restore an old configuration file stored in the flash directory that was
generated with the
system snapshot
command.
To activate a configuration file, use the
flash loader
command.
Note: The restored configuration file will only be activated when the switch is next
rebooted.
Deactivating an active configuration file
To deactivate an active configuration file, use the
flash config disable
command.
Deleting a file from the flash memory bank
To delete a file from the flash memory bank, use the
flash delete
command. You
will be asked to confirm the deletion.
Note:
Once a file is deleted it cannot be recovered. The file must be downloaded
again.
You must not delete the
config.data file without consulting Lucent Technologies
Technical Support.
Command:
M15-155s8:/>flash config <filename>
Example
M15-155s8:/>flash config new_cfile
Parameters:
<filename>
The name of the configuration file that
you wish to activate
Command:
M15-155s8:/>flash config disable
Output:
Active configuration file has been disabled.
Command:
M15-155s8:/>flash delete <filename>
Example
M15-155s8:/>flash delete m770ATM
Parameter:
<filename>
The name of the file you wish to delete
from the flash directory.