Lucent Technologies CAJUN M770, User Manual

Page: 149 / 266

Chapter 10 Managing PNNI Routing
Cajun M770 ATM Switch User’s Guide 131
Remove the PNNI summary address prefix
To remove the PNNI summary address prefix use the following command.
Set the PNNI summary table to the default
Use the following command to set the PNNI summary table to its default values, the
switch’s ATM prefix for lowest level nodes.
PNNI Timers
Show PNNI node timers
Use the following command to show the PNNI node timers:
T
he user is not expected to change any one of these timers. However, if you need
more information about these timers you may refer to the PNNI specification
(af-pnni-0055.000), Annex E: Architectural Variables.
Command:
M15-155s8:/>
route pnni config summary remove <type> <prefix> <len>
Parameters:
<type> - I(nternal) or E(xterior)
<prefix> - The Atm address prefix
each octet is in hex and separate with '.'
<length> - length of the prefix in bits (0-152)
Examples:
set I 39.84.0f.80.01.bc.61.de.81.00.00.60.00 104
Command:
M15-155s8:/>route pnni config summary default
Command:
M15-155s8:/>route pnni config timers show
Examples:
Timers :
Name Index Current Default
Value Value Range Units
-----------------------------------------------------------------
PtseHoldDown 1 10 10 [ 1 - 600] 100ms
HelloHoldDown 2 10 10 [ 1 - 600] 100ms
HelloInterval 3 15 15 [ 1 - 600] secs
HelloInactivityFactor 4 5 5 [ 1 - 20] fctr
HlinkInactivityTime 5 120 120 [ 1 - 600] secs
PtseRefreshInterval 6 1800 1800 [ 60 - 3600] secs
PtseLifeTimeFactor 7 200 200 [100 - 500] %
RxmtInterval 8 5 5 [ 1 - 60] secs
RDelayedAckInterval 9 10 10 [ 1 - 600] 100ms
AvcrPm 10 50 50 [ 1 - 99] %
AvcrMt 11 3 3 [ 1 - 99] %
CdvPm 12 25 25 [ 1 - 99] %
CtdPm 13 50 50 [ 1 - 99] %