Lucent Technologies CAJUN M770, User Manual

Page: 41 / 266

Cajun M770 ATM Switch User’s Guide 23
Chapter 4
Managing Miscellaneous Commands
This chapter describes how to use the command-line interface to set passwords,
address information, and CAC information. For information about how to access
and use the Cajun M770 ATM Switch command-line interface, see Chapter 3 How
to Use the Command-line Interface.
Setting passwords for local/remote connections
To protect the Cajun M770 ATM Switch from accidental or unauthorized
configuration from a local (via the serial port) or remote end-station (via Telnet),
you may want to set a password for the switch.
The following sequence shows you how to set a password for the switch for the first
time. Because no password exists, the M770 ATM Switch does not prompt for the
old password.
Once you have set a password, the CLI will ask you to enter the password each time
you connect to the switch.
To terminate a session and prevent other from configuring the switch type the
command
exit
To delete a password
Enter the old password and press “Enter” for the new password.
Command:
M15-155s8:/>password
Output:
There is no password at the moment.
Enter the new password (does not echo): ********
[ENTER]
Enter the new password again (does not echo):
******** [ENTER]
Password changed.