Lucent Technologies CAJUN M770, User Manual

Page: 88 / 266

Chapter 6 Managing Virtual Ports
70 Cajun M770 ATM Switch User’s Guide
The
vport show config
command displays the information described in Table 6.2.
Table 6.2 Output from the vport show config command
Field Description
Virtual Port Id The virtual port. This is displayed in the format
<slot>.<port>.<virtual port number>.
Admin State The administrative state of the virtual port. If the state is UP
then this virtual port is enabled. If the state is DOWN then this
virtual port is disabled.
This will occur when you disable the virtual port using the
command-line interface or via Management.
Oper State The operational state of the virtual port. If the state is UP then
this virtual port is functional. If the state is DOWN then this
virtual port is not functional. This could be due to a problem
with ILMI or ILMI has been disabled due to a problem with the
physical connection.
ILMI Enabled Whether or not ILMI is enabled on the virtual port.
Poll Mode ILMI polling is used to verify that the same end-station remains
attached at a given port. There are two methods that can be
used:
— check the ESI has not changed. This is referred to as “Port +
ESI”.
— check that the system up-time has not changed by a
significant amount. This is referred to as “SysUpTime”.
Multi Reg This specifies whether multiple ILMI registration is enabled or
not on the virtual port.
Strict AAL
Trans. This specifies whether the translation of the AAL parameter,
that is between UNI 3.0, IISP 3.0, UNI 3.1 and IISP 3.1 should
be OFF, Normal or Strict.
Sig. SSCOP
Rx. Window This parameter is reserved for future use.
All ports are set to the default parameter.
Wait for Peer
SSCOP This specifies whether this vport will wait indefinitely for an
incoming QSAAL connection.