Lucent Technologies CAJUN M770, User Manual

Page: 143 / 266

Chapter 10 Managing PNNI Routing
Cajun M770 ATM Switch User’s Guide 125
Set PNNI interfaces to default values
In order to set PNNI interfaces to default values, use the following command:
PNNI Node Level
Showing PNNI node level
Use the following command to display the PNNI node level.
Setting PNNI node level
Use the following command to set pnni node level. It takes affect only after next
reboot.
Setting PNNI node level to default value
The following command sets the PNNI node level to its default, 56, and it takes
affect only after next reboot.
Command:
M15-155s8:/>
route pnni config interfaces default <ifIndex> <cos>
Parameters:
<ifIndex> - Index number of the interface (or all)
<cos> - Cbr RtVbr NrtVbr Abr Ubr all
Notes: - ifIndex=all : all interfaces will get default parameters
- cos=all : all classes of service for this interface will
get default values.
Command:
M15-155s8:/>route pnni config level show
Examples:
Output:
Level:
Configure: 56
Current : 56
Command:
M15-155s8:/>route pnni config level set < level (1-104)>
Command:
M15-155s8:/>route pnni config level default
Examples:
Warning: This request will set default value (56) for
node level, which will also change the first byte of node
id and peer group id. In addition, it will set the 104-
<level> right-most bits of peer group id to zero.
Changes won't take effect until a reboot is performed on
the entire switch (system reboot switch).
Do you want to continue (Y/N)?