Lucent Technologies CAJUN M770, User Manual

Page: 104 / 266

Chapter 6 Managing Virtual Ports
86 Cajun M770 ATM Switch User’s Guide
Viewing ILMI information for a virtual port
To display ILMI MIB information for the remote end of a virtual port, use the
ilmi show
command.
The
ilmi show
command displays the information described in Table 6.8.
Command:
M15-155s8:/>ilmi show [<vport id>]
Parameters:
<vport id>
The virtual port is displayed in the format:
<slot>.<port>.<virtual port number>.
If no virtual port id is entered then ILMI
information is displayed for all virtual ports.
Table 6.8 Output from the ILMI show command for a specific virtual port
Field Description
Stack Type The Stack Type that the remote device uses for signalling. This
can be UNI 3.0, UNI 3.1, UNI 4.0, IISP 3.0, IISP 3.1 or PNNI 1.0
Private/Public The UNI type that is used. This is either Private or Public.
IP address The IP address of the remote device attached to the virtual
port.
OSI NSAP
address The Open Systems Interconnection (OSI) Network Service
Access Point (NSAP) address. An OSI NSAP address is an
address to which a management station can send network
management protocol messages to access network
management information about the operation of the ATM
device local to this UNI Management Entity (UME).
IfName The textual name of this interface.
MaxVpiBits The maximum VPI bits. This, together with the MaxVpc,
determines the limits of the VPI range that can be supported.
MaxVciBits The maximum VCI bits. This, together with the MaxVcc,
determines the limits of the signalling VCI range that can be
supported.
MaxVpc The maximum Virtual Path Connections (VPCs) that the
remote device can support.
MaxVcc The maximum Virtual Circuit Connections (VCCs) that the
remote device can support.