LS ELECTRIC H100 0008-2(PLUS), Manual

Page: 14 / 239

Quick Start Reference
Q
xiv
Basic Setup
The basic drive and motor parameters are shown on the below table. Set the parameters according
to your specific application.
1. Motor Parameters
Set the below motor parameters based on the motor nameplate.
Group No Description Default Set Options
DRV 14 Motor Capacity Depends on drive Depends on drive
BAS 11 Poles 4 2 - 12
BAS 13 Motor Rated Current Depends on drive Depends on drive
BAS 15 Motor Voltage Depends on drive Depends on drive
▶
Motor RPM to Poles chart
RPM 3600 1800 1200
Poles 2 4 6
▶
Example:
If actual motor RPM is 3450, Set Motor Poles = 2. This is due to motor slip. In this example, the
motor has 150 RPM of slip. (Slip=Synchronous speed-Rated Speed)
2. Commonly Set Parameters
Group No Description Default Set Options
DRV 1 Command Freq 0.00 0
– Max Freq
DRV 3 Acc Time 20 0
– 6000
DRV 4 Dec Time 30 1
– 6000
DRV 6 Run Command 1. Fx/Rx - 1
0. Keypad
1. Fx/Rx - 1
2. Fx/Rx - 2
3. Comm RS485
4. Field Bus
DRV 7 Freq Command 0. Keypad - 1
0. Keypad - 1
1. Keypad - 2
2. V1
4. V2
5. I2
6. Comm RS485
8. Field Bus
12. Pulse
BAS 19 Input Voltage 240/480 170
– 480V
3. Optional Parameters
To automatically start after a power loss, set ADV 10=Yes.
Enable phase loss protection by setting the dipswitches in PRT 05 both up.