LS ELECTRIC H100 0008-2(PLUS), Manual

Page: 11 / 239

xi
Quick Start Reference
Control Wiring
This step shows common wiring examples for both the run command and frequency reference
when operating in AUTO Mode. However, when DRV-
08 Auto Mode Sel is set to “1. Disabled”
(Factory default), it’s available to operate without trasffering to “AUTO Mode”.
2-Wire Control
2-wire control consists of maintained run signals. This can be accomplished via toggle switches,
relays, jumpers, etc. Default parameters support this operation.
Speed POT Wiring (0-10VDC)
Controlling the VFD with an external speed POT can be accomplished by setting DRV7=2 V1
and wiring like below. For 0-10VDC signals from a BAS or Controller simply wire to V1 and CM.
BAS or Controller Wiring (4-20mA)
For speed control over a 4-20mA signal set DRV7=5. I2.
Important: Verify that SW4 dip
switch on the termi
nal board to ‘I2’
(LEFT) for 4-20mA signal.