Lighthouse SOLAIR 3350, Operating Manual

Page: 70 / 184

Lighthouse SOLAIR 3350, 5350 Gen E Operating Manual
6-6 248083387-1 Rev 10
•
AC Indicator:
Indicates that the instrument is being powered with
its AC power cord. If the battery is installed, the instrument will
charge the battery when the instrument is plugged in.
WARNING:
If the Air
Flow is insufficient, check
for and remove any
obstructions. If the issue
persists, turn the
instrument off and contact
Lighthouse Worldwide
Solutions technical support
at 800-945-5905 (USA Toll
Free) or 541-770-5905
(Outside of USA).
•
Flow Status:
When the instrument is sampling, the Flow Indicator
will display sufficient or insufficient flow.
•
Service Indicator:
Indicates that the instrument may be in need of
service. If wrench displays, please contact an authorized
Lighthouse Service Provider at 800-945-5905 (USA Toll Free) or
541-770-5905 (Outside of USA) for assistance or send an email to
techsupport@golighthouse.com.
•
μ
:
The mu symbol indicates the particle sizes, in micrometers,
configured for the instrument. These sizes are pre-configured at the
factory. To order an instrument with non-standard sizes, please
contact a sales representative at Lighthouse 510-438-0500 (Sales).
• DATA DISPLAY:
This indicates whether the counts are being
displayed in Differential (Diff) mode or in Cumulative (Cuml)
mode and, if the counts are normalized to ft
3
or m
3
.
• MODE:
Displays the current mode selected; possible modes are
AUTO, MANUAL, CONCEN (Concentration) and BEEP.
• CYCLES:
Indicates the number of times that the count will be
taken at a given location in Auto mode. "1/ 3" indicates that the
count is the first of three samples to be recorded at this location.
The maximum number of cycles is 999. When set to 0, the unit will
run in Auto mode continuously until the STOP button is pressed.
Insufficient Sufficient
Differential Cumulative
Normalized ft
3
Normalized m
3