Lighthouse SOLAIR 3350, Operating Manual

Page: 109 / 184

Operate Counter
248083387-1 Rev 10 6-45
the instrument the user will be required to enter the correct password
each time the instrument is turned on.
To restrict who can configure the instrument, enable the Configuration
password. When the Configuration password is enabled, the user will
be required to enter the correct password before they can access the
Configuration screen.
• To set the password for the POWER ON, select the POWER ON
button, then type in a password using the numeric keypad. Press the
ERASE button to delete the last character, if needed.
• Press ENTER to save.
• To set the Configuration password, select the CFG button, then type
in a password using the numeric keypad.
• Press the ERASE button to delete the last character, if needed.
• Press ENTER to save the changes.
• Press the “
X
” button to enable either or both passwords.
Press BACK to return to the Configuration screen or press MAIN to
return to the MAIN screen.
POWER ON PASSWORD
WARNING:
Be sure to
record the unit’s passwords
in a safe place. If the
password is lost or
forgotten, contact
Lighthouse technical
support at 800-945-5905
(USA Toll Free) or 541-
770-5905 (Outside of
USA) for assistance. The
unit may have to be
returned to the factory to
reset the password.
To require that a password must be entered before the instrument can be
used, enable the POWER ON password. See Figure 6-60.
Figure 6-60 POWER ON Password Access Screen
When the POWER ON password is enabled, the user will see a
password access screen just after they turn the unit on. The instrument
will remain locked until the correct password is entered.