Lighthouse SOLAIR 3350, Operating Manual

Page: 66 / 184

Lighthouse SOLAIR 3350, 5350 Gen E Operating Manual
6-2 248083387-1 Rev 10
WARNING:
To prevent damage to the instrument, water, solvents or
other liquids of any type should never be allowed to enter the
instrument via the inlet tube. Failure to heed this warning will void the
warranty.
8. If analog sensors were ordered, plug them into the connectors
labeled 1 or 2 on rear of the instrument.
9. On the touch screen, press the “START” button to start the
instrument.
10. "STARTING" will display when the pump is initially turned on.
WARNING:
Never
operate the instrument
with the inlet tube
capped or plugged.
Failure to heed this
warning may damage
the internal pump and
void the warranty.
11. When the SOLAIR starts counting, "COUNTING" appears on the
display. Particle counts are displayed according to the size of each
particle.
12. If the instrument has been programmed with a delay before
starting the pump, it displays, “DELAY”.
13. If the 5-Sec Startup is set (default), “STARTING” will display for
five seconds when the pump turns on.
14. If the instrument is in AUTO mode with cycles and a hold time,
“HOLDING” will display after each cycle and “FINISHED” will
display when all the cycles are complete.
15. Press the "STOP" button to stop the instrument before the cycles
are complete.
Note: If The Display does not respond to touch or responds
incorrectly, power the instrument down then press and hold
in the center of the screen while applying power; the
instrument should respond with the alignment screen;
release pressure on screen. Use the tip of a retracted ball
point pen to touch the required spots on the screen.
Excessive pressure may puncture the screen so use care
during this procedure. For additional information, see
“ALIGN TOUCH SCREEN” on page 32.