POWER CORE User Manual
Version: V6.0.0/5
79/459
9. Audio Mix Engine
Src Repl Element Nr
Src Repl Name
These fields are used to couple the source to an external source in an Ember+ consumer. The
Src Repl Element Nr
should match that defined in the
Src Repl
Name
should match the display name configured in the Ember+ consumer.
List Enable
Select this checkbox if you wish the source to be added to the source selection list when
assigning sources from the control surface.
Audio Input
Selects the audio input for the source.
Limiter
Compressor
Equaliser
Delay
Tick these checkboxes to assign signal processing to the source. Note that:
Compressor
represents the Dynamics (Gate, Expander and Compressor) section.
DSP is not available for surround sources.
Lim Op Disable
Comp Op Disable
Eq Op Disable
Dly Op Disable
On
sapphire MK2
systems, all 96 Sources are configured with
and
. Tick these check boxes to prevent the operator adjustment of DSP parameters for certain
sources. Note that:
Compressor
represents the Dynamics (Gate, Expander and Compressor) section.
De-Esser/AutoMix
Available on mono and stereo sources only. Select this checkbox to assign one of the 32
processors to the source. Note that each function (De-Esser and AutoMix) can
be enabled by the operator independently.
Nova17/MTx Server
Available on stereo sources only. If the audio input to the source is assigned from a remote
matrix, then this option selects the method of communication:
·
Turn the option
On
if the remote matrix is a Nova17, Nova29 or Matrix Server.
·
Turn the option
Off
if the remote matrix is a Nova73 (for communication via Remote MNOPL).
Once communication is established, you can use the
Matrix Out 1
field to support the transfer
of labels from the remote matrix (to the fader label display on the console).
And/or use the
Class/Pool
field (and Mtx Src Pool element) to provide operator-controlled
selection of audio inputs from the remote matrix. See
Configuring a Matrix Source Pool
.
Matrix Out 1
Available on stereo sources only. This option allows the labels from a remote matrix (as
described above) to appear in the fader strip displays and source's Kpf label.
Enter the
of the remote matrix output which is connected to the source's audio
input.
Class/Pool
Available on stereo sources only. This option will allow an operator to select audio inputs from
a remote matrix directly from the fader strip. See
Configuring a Matrix Source Pool
When using a Nova17, Nova29 or Matrix Server, enter the Pool ID defined in the corresponding
MTX Src Pool element.
When using a Nova73, enter the class configured in the Nova73 map (as described in the
"ext_router_control_en.pdf"
available from the
Download-Center
at
(after
Login
).
RAVENNA
OFF / ON. When set to ON, the source becomes a RAVENNA source that can
streams available on the network.
RAVENNA Pool No.
Up to 6 pools can be defined to shape the availability of streams, and whether a particular
stream can be selected by this source. Note that a
element must be
defined to support this setting. See
Configuring RAVENNA Pool Sources
Fader Open
Tick this box if you wish the level of the source to be set to 0dB rather than - infinity. This is
particularly useful for sources which are not to be assigned to the control surface.
Input Mute
Selects an input control signal to mute the audio input.
This mute occurs at the point before the signal is distributed in the matrix, therefore will affect
routes to other destinations as well as to the selected source. (To mute the source within the
‘channel’, see
.)
The mute is active until the input control signal = Logical “1”.
Fader Up
Opens the source fader (see also
Hold Mode
below).
