POWER CORE User Manual
Version: V6.0.0/5
208/459
13. Control Surface Configuration
13.5.2 Configuring the Rotary Controls
These parameters configure the rotary 'VCA' controls on the Central Module:
Control n
Enter a reference name for the control on the Central Module.
Name
Enter the name which will appear on the OLED display beside the control. You can enter up
to 6 characters.
Default Gain (dB)
Enter a default value in dB. Note that -60dB corresponds to - infinity.
This gain is applied after a cold start and whenever the Set Default Gain control signal (see
below) is active.
Gain Step Width
Select an option from the drop-down menu. This sets the gain to change in steps of 1dB,
2dB, 3dB or 5dB.
Set Default Gain
Assign a control signal to activate the
Default Gain
value. For example, you could assign the
warm start control signal if you wish the level to be reset after a restart.
Gain Sync Input
Assign the output of another
. You can use this parameter to link controls. For
example, to have the headphone level follow the studio monitor level or vice versa.
Balance Enable
Tick this box to enable balance control. When enabled, operators can push down and turn
the control to adjust balance.
Balance Sync Input
Assign the output of another
. You can use this parameter to link controls.
For example, to have the headphone balance follow the studio monitor or vice versa.
13.5.3 Additional Module Settings
These are configured in a similar manner to the
13.5.4 Central Modules (monitor mode)
For the each additional Central Module running in monitor mode, parameters are configured in the same way as
for the
