Advanced Configuration
89
Function: Select two ring ports.
Caution:
A ring port or backup port cannot be added to a trunk group. A port added to a trunk group
cannot be configured as a ring port or backup port.
A ring port or backup port can be configured as a mirroring source or destination port. A
mirroring source or destination port cannot be configured as a ring port or backup port.
STP cannot be enabled on a ring port or a backup port. An STP-enabled port cannot be
configured as a ring port or backup port.
Primary Port
Options: Disable/All switch ports
Default: Disable
Function: Configure the primary port.
Description: When the ring is closed, the primary port is in forwarding state.
Caution:
The primary port takes effect only when the ring is closed.
The primary port must be one of the two ring ports on the master.
DT-RING+
Options: Enable/Disable
Default: Disable
Function: Enable or disable the DT-Ring+ function.
Backup Port
Options: All switch ports
Function: Select one port as the backup port.
Explanation: You can configure a backup port only after the DT-Ring+ function is enabled.
Add VLAN List
Options: All created VLANs
Function: Select the VLAN whose packets are allowed through on the current ring port.
Summary of Contents for SICOM3024P
Page 13: ...Product Introduction 6 management software and SNMP network monitoring...
Page 25: ...Device Status 18 Figure 15 System Operating Information SICOM3024...
Page 73: ...Advanced Configuration 66 Figure 67 Setting ACL Entry Parameters Group 2...
Page 145: ...Advanced Configuration 138 Figure 137 Dynamic Unicast FDB Table...
