KYLAND Technology SICOM3024P, Web Operation Manual

Page: 93 / 147

Advanced Configuration
86
Caution:
Link status change affects the status of backup ports.
6.12.4 Explanation
DT-Ring configurations should meet the following conditions:

All switches in the same ring must have the same domain number.

Each ring can only have one master and multiple slaves.

Only two ports can be configured on each switch for a ring.

For two connected rings, backup ports can be configured only in one ring.

Multiple backup ports can be configured in one ring.

On a switch, only one backup port can be configured for one ring.

DT-Ring-Port and DT-Ring-VLAN cannot be configured on one switch at the same time.
6.12.5 Web Configuration
1. Configure redundant ring mode, as shown in the following figure.
Figure 86 Redundant Ring Mode Configuration
Select Redundancy Mode
Options: DT-RING-PORT/DT-RING-VLAN
Default: DT-RING-PORT
Function: Select the redundancy mode.
Check Loop Status
Options: Disable/Enable
Default: Disable
Function: Enable or disable ring status detection.
Description: After ring status detection is enabled, the switch automatically detects ring
status. When a non-ring port receives DT-Ring packets, the port will be locked. Therefore,