Advanced Configuration
91
Figure 92 DT-Ring State
6.12.6 Typical Configuration Example
As shown in Figure 85, Switch A, B, C, and D form Ring 1; Switch E, F, G, and H form ring 2.
Links CE and DF are the backup links between Ring 1 and Ring 2.
Configuration on Switch A:
1. Domain ID: 1; Domain name: Ring; Ring port: port 1 and port 2; Station type: Slave;
DT-Ring+: Disable; do not set backup ports, as shown in Figure 88.
Configuration on Switch B:
2. Domain ID: 1; Domain name: Ring; Ring port: port 1 and port 2, no primary port; Station
type: Master; DT-Ring+: Disable; do not set backup ports, as shown in Figure 88.
Configuration on Switch C and Switch D:
3. Domain ID: 1; Domain name: Ring; Ring port: port 1 and port 2; Station type: Slave;
DT-Ring+: Enable; Backup port: port 3, as shown in Figure 88.
Configuration on Switch E, Switch F, and Switch G:
4. Domain ID: 2; Domain name: Ring; Ring port: port 1 and port 2; Station type: Slave;
DT-Ring+: Disable; do not set backup ports, as shown in Figure 88.
Configuration on Switch H:
5. Domain ID: 2; Domain name: Ring; Ring port: port 1 and port 2, no primary port; Station
type: Master; DT-Ring+: Disable; do not set backup ports, as shown in Figure 88.
Summary of Contents for SICOM3024P
Page 13: ...Product Introduction 6 management software and SNMP network monitoring...
Page 25: ...Device Status 18 Figure 15 System Operating Information SICOM3024...
Page 73: ...Advanced Configuration 66 Figure 67 Setting ACL Entry Parameters Group 2...
Page 145: ...Advanced Configuration 138 Figure 137 Dynamic Unicast FDB Table...
