Advanced Configuration
110
Range: {0~7, 0~3}
Default: Priority 0 to 7 is mapped to queue 0.
Function: Configure the mapping between IP TOS priority and queue.
6. Configure DSCP priority-queue mapping.
Click <DSCP Priority> in Figure 104 to configure the DSCP priority-queue mapping, as
shown in the following figure.
Figure 109 DSCP Priority-Queue Mapping
DSCP Priority
Portfolio: {DSCP, Qos Queue}
Range: {0~63, 0~3}
Default: Priority 0 to 63 is mapped to queue 0.
Function: Configure the mapping between DSCP priority and queue.
6.15.5 Typical Configuration Example
The following uses SICOM3024P as an example to describe QoS configuration.
As shown in the following figure, port 1, port 2, port 3, and port 4 forward packets to port 5.
Summary of Contents for SICOM3024P
Page 13: ...Product Introduction 6 management software and SNMP network monitoring...
Page 25: ...Device Status 18 Figure 15 System Operating Information SICOM3024...
Page 73: ...Advanced Configuration 66 Figure 67 Setting ACL Entry Parameters Group 2...
Page 145: ...Advanced Configuration 138 Figure 137 Dynamic Unicast FDB Table...
