Advanced Configuration
90
After the configurations are completed, created rings are listed in the DT-RING List, as
shown in the following figure.
Figure 90 DT-Ring List
4. View and modify DT-Ring configuration.
Click the DT-Ring options in the preceding figure. You can view and modify the
configurations of the ring, as shown in the following figure.
Figure 91 DT-Ring Configuration
Click <Apply> for changes to take effect after modification. Click <Delete> to delete the
DT-Ring configuration entry.
5. View DT-Ring and port status, as shown in the following figure.
Summary of Contents for SICOM3024P
Page 13: ...Product Introduction 6 management software and SNMP network monitoring...
Page 25: ...Device Status 18 Figure 15 System Operating Information SICOM3024...
Page 73: ...Advanced Configuration 66 Figure 67 Setting ACL Entry Parameters Group 2...
Page 145: ...Advanced Configuration 138 Figure 137 Dynamic Unicast FDB Table...
