Advanced Configuration
107
IP TOS/DSCP
Options: DSCP MODE/IPTOS MODE
Default: DSCP MODE
Function: If TOS/DIFF is selected, you need to select IP TOS or DSCP in this parameter.
DSCP mode indicates the DSCP priority-queue mapping mode and IP TOS mode indicates
the IP TOS priority-queue mapping mode.
2. Configure the queue weight ratio, as shown in the following figure.
Figure 105 Configuring Queue Weight Ratio
{3-HIGHEST, 2-SECHIGH, 1-SECLOW, 0-LOWEST}
Range: {1~55, 1~55, 1~55, 1~55}
Default: {8, 4, 2, 1}
Function: Configure the queue weight ratio by obeying the following rules:
Weight of queue 3 ≥ 2 × Weight of queue 2, Weight of queue 2 ≥ 2 × Weight of queue 1,
Wei
ght of queue 1 ≥ 2 × Weight of queue 0
3. Configure QoS port priority mapping mode, as shown in the following figure.
Summary of Contents for SICOM3024P
Page 13: ...Product Introduction 6 management software and SNMP network monitoring...
Page 25: ...Device Status 18 Figure 15 System Operating Information SICOM3024...
Page 73: ...Advanced Configuration 66 Figure 67 Setting ACL Entry Parameters Group 2...
Page 145: ...Advanced Configuration 138 Figure 137 Dynamic Unicast FDB Table...
