Advanced Configuration
126
Select the member port for the agent entry. The port can only be selected from GMRP
agent-enabled ports.
Source Port List
Options: all GMRP agent-enabled ports
4. View, modify, or delete a GMRP agent entry, as shown in the following figure.
Figure 124 GMRP Agent Entry Operations
A GMRP agent entry consists of the MAC address, VLAN ID, and member port. To delete an
entry, select the entry and click <Delete>. To modify an entry, select the entry and click
<Modify>.
5. View the multicast members of this agent entry on the connected neighbor device as
shown in the following figure.
The following conditions shall be met.
GMRP is enabled on the inter-connected devices.
The two ports that connect the devices must be propagation ports, and the VLAN ID of the
propagation port on the local device must be identical with that in the agent entry.
Figure 125 GMRP Dynamic Multicast Table
GMRP Dynamic Multicast List
Portfolio: {Index, Multicast MAC, VLAN ID, Member Port}
Function: View GMRP dynamic multicast entries.
6.21.5 Typical Configuration Example
As shown in the following figure, Switch A and Switch B are connected through port 2. Port 1
Summary of Contents for SICOM3024P
Page 13: ...Product Introduction 6 management software and SNMP network monitoring...
Page 25: ...Device Status 18 Figure 15 System Operating Information SICOM3024...
Page 73: ...Advanced Configuration 66 Figure 67 Setting ACL Entry Parameters Group 2...
Page 145: ...Advanced Configuration 138 Figure 137 Dynamic Unicast FDB Table...
