Advanced Configuration
75
Range: 10~60 minutes
Default: 20 minutes
Function: Configure ARP aging time.
Description: ARP aging time is the duration from when a dynamic ARP entry is added to the
table to when the entry is deleted from the table.
2. Add a static ARP entry, as shown in the following figure.
Figure 73 Adding a Static ARP Entry
ARP address
Portfolio: {IP address, MAC address}
Format: {A.B.C.D, HHHHHHHHHHHH} (H is a hexadecimal number.)
Function: Configure a static ARP entry.
Caution:
The IP address of a static ARP entry must be on the same network segment with the IP
address of the switch.
If the IP address of a static entry is the IP address of the switch, the system automatically
maps the IP address to the MAC address of the switch.
In general, the switch automatically learns ARP entries. Manual configuration is not
required.
3. View or delete an ARP entry, as shown in the following figure.
Summary of Contents for SICOM3024P
Page 13: ...Product Introduction 6 management software and SNMP network monitoring...
Page 25: ...Device Status 18 Figure 15 System Operating Information SICOM3024...
Page 73: ...Advanced Configuration 66 Figure 67 Setting ACL Entry Parameters Group 2...
Page 145: ...Advanced Configuration 138 Figure 137 Dynamic Unicast FDB Table...
