Advanced Configuration
62
specified value, then the condition is met.
L3 Format
Options: None/L3_Others/IPV4_without_frag/IPV6_without_exten
Default: None
Function: Configure the Layer-3 Internet protocol. None indicates this rule is not used;
L3_Others indicates all the Layer-3 Internet protocols except IPV4_without_frag and
IPV6_without_exten. When the Layer-3 Internet protocol of a packet is consistent with the
specified value, then the condition is met.
L4 Format
Options: None/L4_Others/TCP/UDP/ (ICMP/IGMP)
Default: None
Function: Configure the Layer-4 protocol type. None indicates this rule is not used;
L4_Others indicates all the protocols except TCP, UDP, ICMP, and IGMP. When the Layer-4
protocol type of a packet is consistent with the specified value, then the condition is met.
Same IP
Options: Disable/False/True
Default: Disable
Function: Check whether the source IP address of a packet is identical with its destination IP
address.
Disable indicates the rule is not used.
False indicates the condition is met if the source IP address of a packet is different from its
destination IP address.
True indicates the condition is met if the source IP address of a packet is identical with its
destination IP address.
Same L4 Port
Options: Disable/False/True
Default: Disable
Function: Check whether the source Layer-4 port number of a packet is identical with its
destination Layer-4 port number.
Disable indicates the rule is not used.
Summary of Contents for SICOM3024P
Page 13: ...Product Introduction 6 management software and SNMP network monitoring...
Page 25: ...Device Status 18 Figure 15 System Operating Information SICOM3024...
Page 73: ...Advanced Configuration 66 Figure 67 Setting ACL Entry Parameters Group 2...
Page 145: ...Advanced Configuration 138 Figure 137 Dynamic Unicast FDB Table...
