6 | Function description
The user interface
6.4.5 The status bar
Save target position
X-Axis
Y-Axis
Z-Axis
Angle of rotation
The status bar at the bottom of the screen contains the Save target position button
on the left and shows the current position of the X and Y axles on the right, as well
as the Z axle and the rotation angle of the pick-and-place nozzle. If you are logged
in as an administrator, you can change these parameters from here.
a) To do so, click on the corresponding value in the status bar.
ð
A window where to enter the position or the angle of rotation will open.
Move X-Axis
Go to:
Cancel
b) Enter the new value and click on [OK].
– To move the X axle to the left, the value must be reduced (negative) (minimum
–950,000, maximum 0).
– To move the Y axle forward, the value must be increased (minimum –20,000,
maximum 350,000).
– To lower the pick-and-place nozzle, the value must be increased (minimum 0,
maximum 77000).
– To turn the pick-and-place nozzle clockwise, the value must be increased (6500
corresponds to approximately a 360-degree rotation).
– You can also easily move the axles with the key combination [Ctrl] + [Arrow
key].
The [Save target position] button
Save target position
For larger series of a rework task, it is appropriate to save also the coordinates of
the [Target position] of a component in the profile. This is especially true if the
same components must be always processed in the same [Target position]. When
the process starts, the head will always immediately move to the specified [Target
position].
The [Save target position] button will become activatable during the process when
the target position is reached.
The target position can also be saved in the profile, in the [Placement] tab with the
[Target-X] and [Target-Y] input fields. With regard to this, please also read Chapter
Customizing the placement process in the [Placement] tab [
Ersa GmbH
3BA00207_01 Operating Instructions HR 600_2 | Rev. 3
84 / 169
