Kramer VS-1616DN-EM, User Manual

Page: 26 / 156

Kramer Electronics Ltd.
VS-1616DN-EM
– Using the Configuration Menus
23
Using the Configuration Menus
The configuration menus on the OUTPUTS/INPUTS LCD display let you configure the
VS-1616DN-EM to best suit your needs. There are two configuration menus:
•
Setup Menu
—those that are accessed on a regular basis (for example, storing setups
and setting the delay), see Using the Setup Menu on page 23 .
•
Config Menu
—those that are accessed only occasionally (for example, setting the
interface or communication protocol), see Using the Config Menu on page 27 .
The following rules apply to the menu operation:
•
If no selection is made within approximately 15 seconds, the operation times-out and the
display reverts to the output/input display.
•
At any point in the Menu, press ESC to move up one level or press BREAKAWAY to exit
the Menu altogether.
•
At any point in the Menu, only buttons that are active light or flash.
All the procedures in this section assume that you are starting the procedure from the
standard, operational output/input display.
Using the Setup Menu
The Setup Menu provides access to settings that are regularly changed and comprises the
following options:
•
1: inXX=>ALL , switching one input to all outputs (see Setup Menu
—1:
inXX=>ALL on page 23 ).
•
3: outXX=OFF , turning off an output (see Setup Menu
—3: outXX=>OFF
on page 24 ).
•
7: EDID , assignment to an output (see Setup Menu
—7: EDID
on page 24 ).
•
9: Delay setting for an output (see Setup Menu
—9: Delay
on page 25 ).
•
4: store setup XX , storing the setup in a preset (see Setup Menu
—4: store
setup on page 26 ).
•
6: recall setup XX , recalling a preset (see Setup Menu
—6: recall setup
on page 26 ).
Setup Menu — 1: inXX=>ALL, Switching One Input to all
Outputs
This option switches one input to all outputs.
To switch one input to all outputs:
1. Press MENU.
The Setup Menu options are displayed.