![background image](http://html.mh-extra.com/html/kramer/vs-1616dn-em/vs-1616dn-em_user-manual_2001300056.webp)
Kramer Electronics Ltd.
VS-1616DN-EM
– Using the Input / Output Cards
53
The
DTAxr-OUT2-F16
configuration table appears as follows:
DTAxr-OUT2-F16 Output Card
Parameter
Description
Default
Volume
Sets the audio output volume (0
–70).
Note
: Not applicable when digital audio is selected.
50
Audio
Balance
Sets the audio output channel balance (0
–100).
Note
: Not applicable when digital audio is selected.
50
Audio Bass
Sets the audio output bass level (0
–15).
Note
: Not applicable when digital audio is selected.
7
Audio
Treble
Sets the audio output treble level (0
–15).
Note
: Not applicable when digital audio is selected.
7
Audio Mute
MUTE
—Mutes the audio input. Audio is unmuted if any of the audio
parameters are modified.
Non-MUTE
—Unmutes the audio input.
Note
: Not applicable when digital audio is selected.
Non-MUTE
Audio Mono
OFF
—Analog output is stereo.
MIX
—Analog output is mono.
Note
: Not applicable when digital audio is selected.
OFF
ST
Sets the direction of the audio port:
0
—Audio is set to input
1
—Audio is set to output
Note
: This parameter affects both audio ports on the card. The direction of
the audio signal is indicated by the I/O LED above the terminal block:
ON
—Audio is set to input
OFF
—Audio is set to output
1
Switch
Speed
When switching between different sources the switching time can be
reduced by setting the fast switch level (Fast Switch or Normal Switch).
Normal
Switch
Reset
Output
Re-power: power cycle the port.
Factory default: perform a factory reset of the port to default values.
Re-power
XTRA
Enables range extender. Off for distances of up to 100m at 4K@60Hz 4:2:0
or 4K@30Hz 4:4:4 or 130m at 2K; On for distances of up to 180m at 1080p
@60Hz @24bpp.
*0:ON, 1:OFF, 2:AUTO.
Note
: Distances are valid when using Kramer BC-UNIKAT cables.
2
Audio
Select
AUD-Embedded
—HDMI audio is selected.
AUD-Analog
—Analog audio from the 16-pin terminal block is selected.
Note
: Not applicable when the audio port is set to output (ST=1).
AUD-
Embedded